My 500 Shapton Glass is separating from the metal backing. Anyone dealt with this? It appears the stone is warping, not the metal.
-Will
Shapton Glass separating from back
-
Afjagjones
- Posts: 220
- Joined: Sun Jan 29, 2017 10:00 pm
- Has thanked: 9 times
- Been thanked: 15 times
-
nakneker
- Posts: 2365
- Joined: Thu Feb 22, 2018 8:37 am
- Location: Taylor, Az
- Has thanked: 185 times
- Been thanked: 142 times
Re: Shapton Glass separating from back
Never heard or seen this, that sounds like something shapton or the retailer would warranty. A few pictures would help us understand what’s going on better.
“The goal is to die with memories, not dreams.”
-
gladius
- Posts: 5346
- Joined: Sun Jan 29, 2017 7:59 pm
- Has thanked: 1201 times
- Been thanked: 1025 times
Re: Shapton Glass separating from back
The backing on Shapton Glass stones is glass...are you referring to SG stones for Edge Pro?
-
Radar53
- Posts: 1948
- Joined: Fri Jan 27, 2017 2:44 am
- Location: Auckland, New Zealand
- Has thanked: 423 times
- Been thanked: 673 times
Re: Shapton Glass separating from back
Hi Will, I'll assume for now that you are talking about EP stones and my short answer is "No!"
Having said this, I have had issues with my EP stones "warping" between uses and started a thread about this - see here viewtopic.php?f=5&t=1726&p=15504&hilit= ... ial#p15504
So, I'm wondering for your situation, if this warping phenomenon was repeated many times, could it then cause some slight de-lamination over time.
Just a left field thought
Having said this, I have had issues with my EP stones "warping" between uses and started a thread about this - see here viewtopic.php?f=5&t=1726&p=15504&hilit= ... ial#p15504
So, I'm wondering for your situation, if this warping phenomenon was repeated many times, could it then cause some slight de-lamination over time.
Just a left field thought
Cheers Grant
Just because you're not paranoid doesn't mean they're not going to get you!!
Just because you're not paranoid doesn't mean they're not going to get you!!
Re: Shapton Glass separating from back
Yes, my SG 500 stone for the EP lifted very slightly off the aluminum blank at one end after a couple of years. I held them apart a bit more, put a small drop of superglue in the gap, gave it a few seconds to drip down in, squeezed it shut and clamped overnight. It has been fine since then.