Belt thinning

Moderator: Bensbites

taz575
Posts: 3333
Joined: Wed Jan 25, 2017 2:54 pm
Been thanked: 21 times

Re: Belt thinning

Post by taz575 »

Let me know how you like that kit!

Nochop!
Posts: 42
Joined: Mon Oct 16, 2017 9:11 pm
Location: NC
Has thanked: 11 times
Been thanked: 9 times
Contact:

Re: Belt thinning

Post by Nochop! »

IMG_20190625_132121_002.jpg
I built my own this year, using three step pulleys and a 1hp. Does the trick. Lite-years better than my 'ol Kalamzoo 1x42. I will probably upgrade to a bought grinder and vfd in the very near future, though.

Nochop!
Posts: 42
Joined: Mon Oct 16, 2017 9:11 pm
Location: NC
Has thanked: 11 times
Been thanked: 9 times
Contact:

Re: Belt thinning

Post by Nochop! »

Also, thinning on a 2x72 with a true platen is so much easier and more precise than any 1x30 or 1x42. Even if your not making knives, and just doing knife work, its a good investment.

Bensbites
Posts: 2256
Joined: Mon Jan 30, 2017 7:42 pm
Location: Massachusetts
Has thanked: 46 times
Been thanked: 31 times
Contact:

Re: Belt thinning

Post by Bensbites »

taz575 wrote:
Fri Jun 19, 2020 1:54 pm
Let me know how you like that kit!
Right now I am excited to work on a huge 11 inch platen. This was one of the videos that pushed me over the edge to the house made design. Certainly a bonus to spend time with my dad having him teach me to weld. While I haven’t actually handled other commercial grinders, I have talked to people in bladesmithing groups who have and this HouseMade design and can compare to other grinders. It’s as good or better than a lot of what’s out there.



https://youtu.be/IxkXHMuconA

taz575
Posts: 3333
Joined: Wed Jan 25, 2017 2:54 pm
Been thanked: 21 times

Re: Belt thinning

Post by taz575 »

That does look nice! I used to have the KMG with flat platen, rotary platen and 8" contact wheel, and VFD. I sold it when I got allergic and couldn't do knife handles anymore, but I found I can work with Micarta, G10 and other stuff like that, so I am looking to get back into it. I found a ton of heat treated blanks and other steels that were rough blanked out, but never heat treated or ground, so I may dabble in making knives from scratch again. I have a home built 2x36" with a 1/2 HP 1750 RPM motor with pulley to gear it down by around half and a 1/2", 1" and 2" contact wheel for handle making. I have done some simple blank re profiling and thinning/convexing on a way to fat fillet knife blank, but it would be sweet to have a 2x72 again. Belts are much easier to find!

Post Reply