Currently Available

Formerly Blackstone Knife Company

Moderator: timos

timos
Posts: 1302
Joined: Wed Jan 25, 2017 3:01 pm
Location: oxford, MA
Has thanked: 10 times
Been thanked: 29 times
Contact:

Re: Currently Available

Post by timos »

Hello,

Ive got this available. I cold forged a bit to bring out a pattern in the steel, I call the finish "ghost cloud". The knife model is called "backpacker"
There is plenty of belly in this design, I wanted to get in as much usable edge as I could in a small length. Specs below:

Steel: 52100 core/ Stainless cladding from Aldo @ New Jersey Steel Baron
Stock Thickness: just under 1/8"
Heat Treat: RC62 by Jarod Todd
Handle: Stabilized Curly Mango from @daliadesigns
Bevel Geometry: Flat grind to .010" behind the edge, tip is what I call "bushcrafter" its pointy but strong enough to do stuff [ATTACH=full]1369691[/ATTACH]
Full tang construction
Pins are G10 and mosaic pin tube.
West systems G flex for epoxy
Blade Length: 3-1/4"
Overall length: 7-3/4"
Width at widest point: 1-1/4"

Asking SOLD shipped CONUS. Thank you for your consideration! Let me know if you have any questions.

ImageImage
Tim Johnson
Oxford, MA

“In the beginner’s mind there are many possibilities, but in the expert’s there are few”
--shunryu suzuki
Image
http://www.timothyjohnsonknives.com
tim@blackstoneknife.com

timos
Posts: 1302
Joined: Wed Jan 25, 2017 3:01 pm
Location: oxford, MA
Has thanked: 10 times
Been thanked: 29 times
Contact:

Re: Currently Available

Post by timos »

Hello,



Ive got this available. I cold forged a bit to bring out a pattern in the steel, I call the finish "ghost cloud". The knife model is called "backpacker"

There is plenty of belly in this design, I wanted to get in as much usable edge as I could in a small length.

this one is a bit different than my previous. The handle is a little more slim and has a slight palm swell. Specs below:



Steel: 52100 core/ Stainless cladding from Aldo @ New Jersey Steel Baron

Stock Thickness: just under 1/8"

Heat Treat: RC62 by Jarod Todd

Handle: Stabilized Curly Mango from @daliadesigns

Bevel Geometry: Flat grind to .010" behind the edge, tip is what I call "bushcrafter" its pointy but strong enough to do stuff
Full tang construction

Pins are G10 and mosaic pin tube.

West systems G flex for epoxy

Blade Length: 3-1/4"

Overall length: 7-3/4"

Width at widest point: 1-1/4"



Asking $180.00 shipped CONUS. Thank you for your consideration! Let me know if you have any questions.

ImageImageImageImageImage
Tim Johnson
Oxford, MA

“In the beginner’s mind there are many possibilities, but in the expert’s there are few”
--shunryu suzuki
Image
http://www.timothyjohnsonknives.com
tim@blackstoneknife.com

Post Reply